timmywa

AWESOME!

Thanks for the detail!

Are you recommending us to uninstall/reinstall on these builds or just over the top?

Also are you using a newer or same VAC? And can you please remove the skinned mouse cursor deal or make it an option? when I VNC to that system, the mouse gets all messy looking.

Thanks again!

[quote author=”Leif”]Maniak, could you try if 1.20.22 works better with your USB headset?
///Leif[/quote]

Leif, what changes from .21 to .22? Could you provide a changelog as we go along, please? I know at the top of this post you mentioned Windows 7 and waveRT capabilities, but was there more?

Also, adding the NR switch to each preset or the the entire engine as it is in Live is still a request I have.

Thanks, as always, you’re incredible!

-Timmy

Does this include a newer VAC? Just wondering if I should re-tune with your resampler.

Try feeding into BA at 48000, while leaving the input at 44,100. Check also if BA is running the pipeline at 48000 (the output), chances are your card is running natively at 48000 see if that works.

Thanks, Leif! I keep learning!

You might unclick the Realtime priority option and see how that works.

As far as using RTA as a scope and meter… You say to check for clipping and distortion at the decoder end. The ways I’ve tried to do this, it’s always affected by whatever I set the volume to. so it’s not really "attached" to the decoder say in Winamp. It’s attached to the wave out. On the receiver end, how would I accurately check if there is clipping with RTA? Jesse showed me a cool winamp dsp plugin that gives me a spectrum analyzer and a meter with clipping indicators and it’s attached right to the decoder and is NOT affected by any volume controls. How do I make RTA do that?

I think your encoder needs to be pulling audio from the soundcard… or the Output from Breakaway’s i/o control. The unprocessed audio is on the pipeline (input on i/o settings).