- This topic has 24 replies, 6 voices, and was last updated 15 years, 8 months ago by
.
-
Posts
-
Have somebody test with vinly and breakaway ?
I have i tested. And i must say the sound is verry nice.
Settings:
M audio delta 1010tl
1. Breakaway Input Mic preamp (delta) > Mic. Rode Broadcaster > Preset Microphone 2 Output > 3/4 > Mixer ch 12. Breakaway Input 3/4 with a preamp phone> line. > Prestet Twente input -18db range 50 power 30 speed 20 > Output 5/6 > Mixer ch 2 Plugins>(Waves Restoration)
Mixer output Master >
3. Breakaway Input 7/8 > Output 1/2 studio sound.
Plugins> BASS EFX(4) and IMPACT(3-2) and SPACTURAS(140%-30ms)
4. Breakaway FM live link. > 3 Output ESI @juli MPX > ether sound.Greats Rob
I played my Kate Bush remix of Running Up That Hill and a few other vinyl goodies I have though Breakaway’s Plutonium preset, and the sound blew me away. It handled the occasional vinyl pop better than any processor I’ve *EVER HEARD*.
Listen to Bassdrive.com
quote :Saturdays, 11am – 2pm CST
“Electronic Warfare”
Hosted by The Overfiend. (New York, NY, USA)I’ve personally worked on this show for the last 5 years. 🙂 Possibly the best sounding show that plays vinyl on the planet. The gear from end to end is PRIME. Over the last 5 years we spent about 50 grand getting it just right. 🙂
About 80% of the stuff played is unreleased and unsigned too, all the best cuts, so if you like Drum & Bass too… this is one of the shows to check out stuff months before it is out. All the top D&B DJs are trainspotting this one. 😉
Yes, we’re also testing BBP with vinyl. The vinyl we play here is a bit older than what the previous two posts were talking about 🙂. This means that the quality differs from record to record, which makes it more difficult to process. You want to be somewhat loud, but not at the expense of sounding really awful 🙂.
We use an Esi Juli@ for input and Breakaway Live output. BBP uses a Soundblaster Audigy 2 ZS that is connected to a (homemade) transmitter.
BBP is using the ‘Twente’ preset with roughly these parameters:
Final drive: +1
Range: 65
Power: 75
Speed: 50
Bass cut: -15
(Impact plugin: 1/1)I recorded some fragments (tuner output -> m-audio delta 44 input), which you download here: http://www.speedyshare.com/189342961.html. I know, it’s compressed, and not the actual MPX signal, but it’s just to give you a rough impression. Also, the tilt was not configured properly yet (we will use a Pira75 analyzer for that).
Personally, I think it sounds quite alright. What bothers me the most are the higher frequencies, which stand out a bit too much (especially when the quality of the record isn’t very good).
sfinx: i must say the sound is is verry nervous, i like a noise gating or something like that.
I will make some record`s to. with mpxtool only not on air. but 75khz 50us of breakaway fmjesseg: thanks i will look for it. these days.
Here a record of me it is mp3 but i you like a .flac i will upload that.
It seems the high-end in the Twente preset is a bit overdone. I think I might tame it down a bit for the next version, maybe?
///Leif
That would be cool. Twente is such an excellent preset. Any attention you can give it (to bring the treble in line with other presets) would pay off a dozen times over.
Okey i must say i like the high end maby a little bit to high. and maby if it possible is put the mid high a little bit higher.
Yes twente is a nice regio and sound.greats rob netherlands twente
[quote author=”Morsink”]sfinx: i must say the sound is is verry nervous, i like a noise gating or something like that.[/quote]
I agree, your recording sounds more ‘open’. Does that Waves Restoration plug have a big impact on the overall sound? Or is it just there to remove the occasional vinyl crack/pop ?[quote author=”Leif”]It seems the high-end in the Twente preset is a bit overdone. I think I might tame it down a bit for the next version, maybe?///Leif[/quote]
Yes, good idea! 🙂Hello,
I’ve got a question for Morsink: What Waves Restoration plugin you use, it sounds very clean without cracks or plops of the vinyl…?
And is this a DSP or VST Plugin?Sfinx also a question for you: I’ve got some information of that Pira75 Broadcast analyzer and you said here
quote :Also, the tilt was not configured properly yet (we will use a Pira75 analyzer for that).that it is possible to configure the Tilt with that broadcast analyzer? Is that true? Because I have not noticed that the broadcast analyzer of Pira75 is a Oscilloscope(computer based)? It’s not mentioned on the Pira.cz website?
Thanks in advance.
[quote author=”SDF”]that it is possible to configure the Tilt with that broadcast analyzer? Is that true? Because I have not noticed that the broadcast analyzer of Pira75 is a Oscilloscope(computer based)? It’s not mentioned on the Pira.cz website? [/quote]
To do this, you use the modulation monitor function of the Pira75 analyzer. See this page: http://www.claessonedwards.com/index.ph … &Itemid=83Thank you for your fast reply 😀
I get it… Just want to know what kind of plugin Morsink is using for Waves Restoration.SDF > you can me speak @ MSN robmorsink@home.nl
waves is a vst plugin i have vst to dsp. for plugin to work with breakaway.
and waves plug ins is only on the vinly channel.
greats
Ah Rob,
Got you already in my list… Sorry didn’t noticed 😛
Thank you for answering.
- The forum ‘Breakaway Professional Products – [discontinued]’ is closed to new topics and replies.