- This topic has 1 reply, 1 voice, and was last updated 4 years, 10 months ago by
.
-
Posts
-
Hi, I tested the Stream receiver with a primary stream on a fiber connection and a secondary stream on a 4G connection.
When I simulate the loss of connection at the fiber connection, the switch to the secondary stream is done correctly by BreakawayOne but after about fifteen seconds, the main stream is reconnected to the 4G network. At that moment I have my primary and secondary stream using the 4G connection.
The secondary stream remains well configured on the 4G connection (because the physical address of the card is entered in Bind).
Is there a specific setting so that my primary stream remains configured on my fiber connection?
Thanks!
I have a kind of workaround myself in that my primary stream is on a local IP only so the 4G cannot see it and is forced to find it over the local network.
You might be able to configure the 4G's settings to exclude the primary stream address so the PC is forced to look for it over the fiber connection. Try looking in the advanced settings of the 4G device's setup page. It might also be possible to do this in the Windows networking settings in that you can blacklist certain addresses over certain network connections.
Other issues however can still remain as other functions on the computer may still use the 4G network, even when fiber is working.
- You must be logged in to reply to this topic.