- This topic has 3 replies, 2 voices, and was last updated 3 years, 8 months ago by
.
-
Posts
-
Hi, testing the Audio HD core, I can connect to a external audio source and activate the streams out, all works, but I don’t seem to be able to adjust the level of the streams, either individually or in common. Adjusting the output level of the audio core does not have any effect on the streams, the audio core is only streaming it does not have any physical audio device linked to it.
How can I adjust the level of the streams in a HD audio core ?
You can try lowering the Final Limiter Drive under Final inside Audio Processor to reduce loudness and give it more headroom. You can also use the Enhance adjustments under Audio Processor. If this isn’t enough, you can save and edit the OUTMIX lines near the bottom of the AMX preset files (open them in a text editor). I wanna say dropping them from 50 to 25 or so should give you something like 6+ db headroom or more if you lower the final limiter drive as well.
edit: Also, to clarify, are you saying you tried the Processor > Misc > I/O > Output?
edit2: There’s also Stream Ateunation -12db on my passthrough core (in trial mode, which I use for local streaming to my phone)
Also, to clarify, are you saying you tried the Processor > Misc > I/O > Output?
Yes, modifying the output level in the Audio HD core I/O as you mentioned does nothing in the stream level, as a side note as I mentioned I do not have a physical device linked to the Output of the HD core.
- You must be logged in to reply to this topic.