Problem after reboot

Home › Forums › BreakawayOne › Problem after reboot

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 27, 2026 at 7:52 am #17787
    timmywa
    Participant

    I scheduled a reboot this morning after some Windows updates. It rebooted around 2:30am and I happened to be awake around 4:00 and saw that my station was offline. I looked in and everything was running except the two encoders were not enabled. I clicked into each one and clicked Enable and things were then fine. Why would that happen? It was all running for around 2-3 months just fine before the reboot. Did some configuration not save correctly that would have set those encoders to be enabled?

    March 27, 2026 at 2:22 pm #17788
    Milky
    Keymaster

    That is strange. Breakaway usually stores all settings, including presets, slider levels, stream, encoders, bypass setting etc, through a re-boot, power outage etc

    Can you simulate a Windows re-boot again and check its behaviour?

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.