- This topic has 5 replies, 3 voices, and was last updated 11 years, 3 months ago by
.
-
Posts
-
Hi Guys;
i get mpx signal from sound card
In calibration help page, There is a sentence which i didn’t understand.Connect the oscilloscope signal and ground to Breakaway Broadcast Processor’s output, in parallel with the load (exciter or stereo generator).
While calibrating, will i use both of two outputs of Esi Juli@ (left and right)
Left output to Exciter
Right output to osiloscobe?what is ‘ in parallel with the load (exciter or stereo generator)’
Thanks
That would mean…
When the output is connected to the input of what you are going to connect it to.
BB 8)
[quote author=”BriansBrain”]That would mean…
When the output is coneected to the input of what you are going to connect it to.
BB 8)[/quote]
what input will i connect? to osiloscobe or to exciter?
how will i connect paralel input?
[quote author=”qsqs”][quote author=”BriansBrain”]That would mean…
When the output is connected to the input of what you are going to connect it to.
BB 8)[/quote]
what input will i connect? to osiloscobe or to exciter?
how will i connect paralel input?[/quote]
Connect your scope when >>> The output is connected to the input of what you are going to connect it to.
😛
It’s so simple…….
[attachment=0:2c2glnm8]bbp.jpg[/attachment:2c2glnm8]BTW: If you input a square and you get a sine wave out, then you have a serious problem in your soundcard….. 😉
- The forum ‘Breakaway Professional Products – [discontinued]’ is closed to new topics and replies.