- This topic has 8 replies, 3 voices, and was last updated 15 years, 2 months ago by
.
-
Posts
-
Hello, I will buy an audio card for BBPA, is a good choice the M-Audio Delta 1010LT, I have been told that you could exit mpx and connect directly to the exciter has to start testing in the air. Any other suggestions? Thanks!
Bad choice. 1010LT does not support 192k at all, so it’s unusable for MPX.
The best choice is this card:
http://marian.de/en/products/trace8
Low latency, DC straight output (no tilt), 8 channels in and out.
It’s €399, though.
If you want a cheaper card, buy an ESI Juli@. It’s also a good card, but it’s not DC straight output so it does need tilt correction, and it’s only 2 channels.
Best,
///LeifIf I choose "Marian" then I need help with the connections … RCA outputs to connect bnc (mpx) of my driver?
The Marian Trace 8 has 1/4 inch (6.3mm) connectors.
Use the following two adapters:
Nothing to it 😉.
///Leif
I’m still confused. I have only one entry in my exciter and one bnc connector… I see is the sign would be mono … mono?
Sorry my ignorance on these issues, but I have a processor "Axel Falcon 35" and I look forward to remove it (I do not like how that works) and be able to BBPA …1 bnc connector is all you need.
BBP ASIO contains a stereo encoder, so you actually get the entire composite stereo signal (mpx) in ONE bnc connector!
BBP will be able to completely replace your existing processor.
///Leif
Leif, Thanks! for your patience, your speed, for the good information … I shall begin testing soon
Fernando.
hi Leif..
i am using ESI Juli@ ..
My question is .. what is the procedure to find and fix Tilt on this card, what tools i need, etc.thanks
- The forum ‘Breakaway Professional Products – [discontinued]’ is closed to new topics and replies.