Julia and BBP

Home › Forums › Breakaway Professional Products – [discontinued] › Julia and BBP

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 14, 2012 at 8:30 am #1331
    Dj Buik
    Member

    I have a question about Input and output rate for the Juli@ soundcard.

    I have the following BBP situation:

    One Juli@ soundcard
    One onboard Realtek soundcard (not 192KHz capable)

    BBP setup:

    Input: Julia Audio (44 KHz) – audio in
    RDS In: Breakaway Pipeline 3 (192 KHz) – Airomate RDS
    L/R Out: Realtek output (44 KHz) – to amplifier
    MPX Out: Julia Audio (192 KHz) – to transmitter

    This won’t pass the Breakaway Test:
    "Unable to open Juli@ Audio for input at 44100Hz, 2 channels.16 bits"

    Question 1: Must the Julia input and output run at the same rate?

    Question 2: What does the Juli@ Clock select (Int/Ext) exactely do?

    May 14, 2012 at 11:40 pm #13244
    bennylein1985
    Member

    Hi

    I think input/output from juli@ must be the same rate.
    You can use the input from the rt onboard card.

    May 15, 2012 at 12:57 am #13245
    didac
    Participant

    Yes, Juli@ must work at same samplerate (192 kHz), then you can use Realtek for input at 44 KHz samplerate, and always with internal clock, external it’s only for an optical input.

    Best regards.

    May 15, 2012 at 2:39 am #13246
    Boki
    Member

    May 16, 2012 at 7:14 am #13247
    Dj Buik
    Member

    Thanks guys you’re very helpful.

    To Boki:

    I have never fully understand the direct wire feature.

    What are you exactely do with this virtual audio cable patch?

    Also i see you configured the Wave interface. Why? Does this not work with the other interfaces?

    Thanks in advance for replying.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • The forum ‘Breakaway Professional Products – [discontinued]’ is closed to new topics and replies.