emu 0404 with bbasio

Hi!

Sometimes seems so difficult but it’s not…

I will explain how I do it and in case that you need screenshots just ask it 😉

How to route audio from a player/application to Emu0404 then to BBP Asio and then back to Emu0404 L/R output speakers).

Start the configuration from BBP asio first.

-Go to I/O configuration and select your card for Asio.
-Select 48000 Hz
-For Left Input select: Asio In 9
-For Right Input select Asio In 10
-For FM Audio Out L select Asio Out 31
-For FM Audio Out R select Asio Out 32

Emu DSP should popup automaticaly to confirm the new 48000Hz session.
If not, from DSP create a new session,select 48K tab, product default preset and click OK button.
Select internal source at 48KHz,leave the I/O settings as it is and click OK.

EMU0404 Configuration:

-Start your source player/application and select as output Emu card.

Normally you’ll get audio at the speakers now via WAVE1/2 strip but nothing at the BBP meters.

-At first strip (WAVE1/2), under the peak meter insert, right click at the first available and add
an insert send HOST ASIO 9/10

This will route source audio to BBP ASIO input and you’ll get back the audio from BBP to strip two (ASIO OUT 31/32).

If you hear your audio two times, just mute the first strip 😉

* If you want to control the input level to BBP, at the first strip, right click to the SEND insert and select to add a trim control insert (SEND insert will go to the third place).
You can adjust the Gain from your source to BBP input from the slider at the right window of DSP.

** In case that you want to route the BBP Asio out directly to the output of Emu before the mixer, at strip two
(ASIO OUT 31/32) under peak meters add an Insert SEND and select PCI Card Out L/R or S/PDIF L/R.

Don’t forget to save the preset !! 😉

Regards,
George