iguman

Forum Replies Created

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • July 15, 2010 at 11:28 am in reply to: upgrading BBP to Asio #10842
    iguman
    Member

    Good question! If I bay BBP now can i upgrade to BBP ASIO later?

    March 30, 2010 at 11:12 am in reply to: problem with impedance ? #10217
    iguman
    Member

    Exciter input impedance is 50 ohm and have adjusts potentiometar for level of modulation

    March 29, 2010 at 7:47 pm in reply to: problem with impedance ? #10214
    iguman
    Member

    No jumper q…

    March 28, 2010 at 9:04 pm in reply to: problem with impedance ? #10212
    iguman
    Member

    but with this resistans i use volume in my card is on maximum

    March 28, 2010 at 1:59 pm in reply to: problem with impedance ? #10210
    iguman
    Member

    from 10 to 1000 ohm…

    March 27, 2010 at 9:50 am in reply to: problem with impedance ? #10208
    iguman
    Member

    I added, but no difference…

    March 26, 2010 at 10:34 am in reply to: problem with impedance ? #10206
    iguman
    Member

    🙂 JesseG i try to rise level on transmitter with lower out on sound card. Also, to rise level on sound card but no success…

    Perhaps i need some addapter or converter from larger (soundcard) to lower (transmitter) impedance. Do you have some elec. schem? 🙂

    March 25, 2010 at 11:17 pm in reply to: problem with impedance ? #10203
    iguman
    Member

    this is hardware

    and have MPX output impedance?

    what cable you suggest me for mpx signal from sound card?

    March 25, 2010 at 8:57 pm in reply to: problem with impedance ? #10200
    iguman
    Member

    from hardware stereo coder mpx out impedance is 50 ohm, using rg58 and sound is ok…. Same cable using for soud card – transmitter connection

    PS. Transmitter does not have impedance swithc

    March 25, 2010 at 6:09 pm in reply to: problem with impedance ? #10198
    iguman
    Member

    It`s logical to me that input inpedance is 50 omh , because is bnc mpx input in link, and its only input. Link is manufactured by db electronics…

    March 25, 2010 at 5:42 pm in reply to: problem with impedance ? #10196
    iguman
    Member

    Yes , both calibrated with oscilloscope

  • Author
    Posts
Viewing 11 posts - 1 through 11 (of 11 total)